Vulcan-Hart VHG-C Series Operation Manual page 35

VHG SERIES GAS FRYERS
THERMAL OVERLOAD PROTECTION BUTTON
The motor/pump supplied with
the filter system has a thermal
overload protection circuit that
senses when excess heat
occurs. This can occur due to
filtering for long periods of
time or under heavy load prior
to discarding debris buildup. If
the thermal overload
protection is tripped, wait 5
minutes and then reset the
motor by pushing in the red
button. The arrow in Figure 8
shows the location of the reset
button; located on the right
side of the motor / pump.
The pump may start immediately when the reset button is pushed and
begin circulating hot oil.
Hot oil and hot parts can cause burns. Use care when operating,
cleaning, and servicing the fryer.
Spilling hot fryer compound can cause severe burns. Do not
move fryer without draining all frying compound from the tank.
Disconnect the power supply to the fryer before servicing.
LUBRICATION
There are no parts that require lubrication.
FLUE VENT INSPECTION
When the fryer is cool, inspect annually. Check the flue and clear any obstructions.
ANNUAL INSPECTION
Contact an authorized service contractor for an annual inspection of the fryer.
SERVICE IN THE US AND CANADA
Contact the factory, the factory representative or authorized service contractor in your area to
perform maintenenace and repairs. For a complete listing of Service and Parts depots refer to
www.vulcanequipment.com.
VULCAN
RESET BUTTON
Fig 8.
MAINTENANCE
-35-
F-47678 Rev. A (3-20)