Vulcan-Hart VHG-C Series Operation Manual page 14

VHG SERIES GAS FRYERS
Turning On Computer Control
1. Open the bottom fryer door and press the power
switch to the ON position.
The controller will power on and begin the dry fire
test.
The display will cycle through showing,
ATFULL?,PUSH CONFIRM TESTING
V and
VAT
(timer countdown) during the dry fire test.
If the dry fire test fails, the display will cycle through
VATFULL?,PUSH CONFIRM.
showing,
The dry fire test can be by-passed by visually
confirming the oil level is correct then press the
CONFIRM button.
2. After the dry fire test is either passed or manually
by-passed, The melt cycle will begin and the fryer will
heat off and on until the vat temperature exceeds
135° F.
The display will show the current melt cycle setting.
The correct melt mode must be set to match the
shortening type used.
Once temperatue exceeds 135°F(or if melt type is set
to NONE),the fryer will heat continuously until the
controller set point is reached.
3. Once the temperature set point is reached, the
display will show READYand the temperature
setpoint.
Pressing the TEMP button will display the set
temperature and the actual temperature for 3
seconds.
VULCAN F-47678 Rev. A (3-20)
-14-