Vulcan-Hart VHG-C Series Operation Manual page 31

VHG SERIES GAS FRYERS
7.Disconnect the discard hose. Be careful to let the hose drain before putting away. Close the drain valve and fill the
fry tank with new oil.
If discard vessel is not large enough to hold the entire shortening amount, stop the flow by pushing the filter
button to to turn the motor/pumpoff. Empty the container and resume discard operation by pressing the filter holding for 3-4
seconds.
If power is mistakenly turned off during the filtering operation, the corrective action is as follows.
1. Close the drain valve
2. Turn the power switch on
3. Immediately open drain valve
4. Continue filtering operation
FILTERING TIP:
Open the filtering drawer approximately 1" to allow any oil in the return line to run back into the filter pan. This will take about
30 seconds to complete. Then open the drawer completely to clean filter components.
Filtering Computer Control
Hot oil and parts can cause burns. Use care when operating,cleaning and servicing the fryer. Do not
leave unattended.
Spilling hot frying compound can cause severe burns. Do not move fryer without draining all frying
compound from the tank.
Never run water or boil out solution through filter and motor / pump. Doing so will void your fryer warranty.
Do NOT turn off the power to the fryer. Leave power on.
Filter ONLY one fry tank at a time to avoid overflow and spillage.
1. Do NOT turn off the power to the
fryer. Leave power on. Vulcan
recommends adding an oil treatment
media to the oil prior to filtering.
Always filter the oil when hot at 300°F
- 350°F.
VULCAN
SUCTION TUBE
RECEPTACLE BLOCK
2. Make sure that the filter drawer is
closed completely and that the suction
tube and receptacle block are in the
correct position.
-31-
3.Slowly open the drain valve to allow
oil to flow from The fry tank to the filter
pan. Then open the drain valve all the
way. The fryer will automatically stop
heating.
F-47678 Rev. A (3-20)