Hyundai 35DS-7 Operation Manual page 87

11) Apply clean T/M oil to the clutch disk and
plate and then assemble 7 clutch disks and
plates in the order of ;
(1) At first, install clutch plate which has teeth
on the outer race.
Install clutch disk which has teeth on the
(2)
inner race.
(3) Repeat (1) and (2) until all of the clutch
plates and disks are assembled.
Install pressure plate inside the cylinder.
12)
Assemble the pressure plate in the right
13)
position and then install snap ring(50) with a
screw driver.
Assemble 3 seal rings(55) on the shaft.
14)
Be careful not to damage seal ring inside
the counter shaft.
15) Refer to 5) ~ 8) for assembling another side
of counter shaft assy.
16) Apply clean T/M oil to the clutch disk and
plate and then assemble clutch disks and
plates in the order of ;
(1)
At first, install clutch plate which has teeth
on the outer race.
(2) Install clutch disk which has teeth on the
inner race.
(3) Repeat (1) and (2) until all of the clutch
plates and disks are assembled.
17) Install pressure plate inside the cylinder.
18) Assemble snap ring(50) fixing the pressure
plate inside the cylinder with a screw driver.
19) Assemble thrust washer and needle bearing
to the high speed clutch couter shaft.
3-45
50
D357TM32
51
D357TM33
50
D357TM34