Hyundai 35DS-7 Operation Manual page 171

(3) Cover assembly
Remove snap ring(20) with proper
tool(Only when it is needed to replace
shaft seal).
Remove the shaft seal(19) taking care
not to give any damage on the surface of
shaft hole(Only when it is needed to
replace shaft seal).
4 4 ) R R EASSEMBLY
Cover assembly
(1)
Insert the shaft seal(19) carefully and fit it
inside of cover with proper tool.
Fit the snap ring(20) in pre-arranged
position with proper tool.
(2) F F ront section
Fit the parker ring(17) on the pre-arrang-
ed groove of the body(27).
Smear clean grease on the parker ring to
avoid drifting away of parker ring from the
body.
Locate the seals(16) on the groove pre-
arranged on the thrust plate(5).
Then, locate back-up ring(22) on the
groove pre-arranged on the seals(16).
Smear clean grease on the seals(16,
22).
(The front and rear thrust plates and
seals and back-up rings are same).
3
3
8
5
16
22
23
6-27
20
19
20
19
17
27
16
22
5
9
D357PMP07
D357PMP07
D357PMP08
23
D357PMP09