Hyundai 35DS-7 Operation Manual page 143

4) ASSEMBLY
In reassembling, have all parts washed, grease
applied to lubricating parts, and all expendable
items such as oil seal and spring washers
replaced by new ones.
Perform the disassembly in reverse order.
(1) Tighten the special bolt(1-7) and washer(1-8) of
king pin(1-4).
There is a notch in the middle of the king pin(6),
(2)
make sure that this notch is on the special bolt
side.
(3) Do not hammer to drive in needle bearing(1-5)
because it will break.
Always use drive-in tool. In assembling the thrust
bearing(1-9), be sure that the fixed ring of the
bearing is placed in position facing the knuckle
(1-3).
(4) Hub
Mount oil seal(1-15) and inner race of tapered
roller bearing(1-16) on the knuckle.
bearing should be well greased before
assembling.
Install the outer race of the bearing(1-17) in the
wheel center and assemble to the knuckle.
Tighten nut(1-8) and lock with split pin(1-19). In
locking with split pin, locate the hole for the split
pin by turning the nut back 1/6 of a turn.
Adjust the preload of bearing.
Mount the hub cap(32) and tighten with bolt
(1-38).
Bearing should be well greased before assem-
bling.
1-15
1-16
1-14
The
5-36
1-13
1-12
1-11
1-4
1-5
1-9
1-10
1-3
1-8
1-7
1-6
1-5 1-27
1-21
6
1-17
1-18
1-19
1-20
35 kgf
1-38
1-39
D357SE38