Hyundai 35DS-7 Operation Manual page 86

4) Assemble gear(61) and bearing(60) to the
output shaft.
5) Install seal ring on the piston(54).
Apply T/M oil to seal ring.
6) Assemble seal ring and piston into the
cylinder.
Be careful not to damage seal ring when
assembling pistion.
7) Install spring assembly and retainer(52)
inside the cylinder.
8) Fix axle assembly in a vise and then
pressurize the retainer downward to
assemble snap ring with a screw driver.
9) Assemble pin(59) and 2 thrust washers(57)
inside the counter shaft of low speed clutch.
10) Assemble needle bearing, spacer, gear(58),
thrust washer(60) and bearing(56).
60
61
57
59
3-44
D357TM29
54
52
53
D357TM23
55
56
60
58
D357TM211