Hyundai 35DS-7 Operation Manual page 68

(2) Using different kinds of shims, adjust shim
thickness as measured by previous
equation. Place shims at the bearing
place.
Using a jig, assemble drive bearing so that
the outer race contact with the bearing
place.
(3)
Heat inner race of bearing to max 100
and then assemble it to the pinion shaft.
Also inner race should contact with
bearing place.
Measuring play of bevel pinion shaft end
Measure shim thickness by following
method.
Dimension "Q" : Distance from bearing
outer race surface to spacer surface.
Dimension "P" : Distance from bearing
outer race surface to inner race surface.
From the below equation, define required
shim thickness Z.
" Z = P - Q "
EX) : From the bearing
P = 2.25 (0.09
mm
From the housing
Q = 1.85 (0.07
mm
Required shim thickness Z :
Z = 2.25 - 1.85 = 0.40
P
2.15(0.085) 1.85(0.073)
2.20(0.087) 1.85(0.073)
2.25(0.089) 1.85(0.073)
2.30(0.091) 1.85(0.073)
2.35(0.093) 1.85(0.073)
C
)
in
)
in
(0.02 )
mm in
Unit : mm(in)
Q Z
0.30(0.012)
0.35(0.014)
0.40(0.016)
0.45(0.018)
0.50(0.020)
Q
P
3-26
D357DA241
D357DA25
2
D357DA261
D357DA271