Hyundai 35DS-7 Operation Manual page 72

4) ASSEMBLY OF CARRIER
Assemble carrier assembly into the axle
(1)
housing.
Apply loctite #271 or #277 to thread of bolt
(2)
and then assemble at the tightening torque
of 11~12 (79.6~86.8
kgf m
5) ASSEMBLY OF WHEEL HUB
(1) Insert bearing into wheel hub.
Confirm that the bearing and wheel hub
contact completely.
Apply grease or oil to shaft seal and
then assemble it from the direction of
outer side of wheel hub.
(2) Install wheel hub assembly to the tube
flange of axle completely.
Install bearing cone.
(3) Insert shim, fix the torque plate and ring
gear with snap ring and assemble them to
the axle tube.
Apply loctite #271 or #277.
Apply grease on the bushing.
).
lbf ft
3-30
1
D357DA37
D357DA38
D357DA37
12
D357DA39