Hyundai 35DS-7 Operation Manual page 134

(25) Place the cardan shaft as shown - so that
it is held in position by the mounting fork.
(26) Grease the two O-rings with mineral oil
approx. viscosity 500 cSt at 20
place them in the two grooves in the gear
rim. Fit the gearwheel and rim on the
cardan shaft.
(27) Important
Fit the gearwheel(Rotor) and cardan shaft
so that a tooth base in the rotor is
positioned in relation to the shaft slot as
shown.
Turn the gear rim so that the seven
through holes match the holes in the
housing.
(28) Fit the spacer, if any.
C and
5-27
5-83(1)
5-83(2)
5-83(3)
5-83(4)