Hyundai 35DS-7 Operation Manual page 83

27) After removing snap ring(50) and then
disassemble 7 disks and 7 plates from the
cylinder.
28) Remove 2 thrust washers(57) and a pin(59).
29) By pressing the retainer(52), remove snap
ring(53).
Carefully reducing tension of spring
assembly, remove retainer and spring.
30) Using a air compresser, remove piston(54)
and pull out O-ring.
Disassembling procedure of Input shaft
assembly is same as that of counter shaft
assembly.
31) Disassemble input shaft assembly.
32) Remove bearing(60) and gear(61) from the
output shaft assembly.
50
57
59
60
61
3-41
D357TM22
54
52
53
D357TM23
D357TM24