Hyundai 35DS-7 Operation Manual page 124

(9) Take care to keep the cross pin in the
sleeve and spool horizontal. The pin can
be seen through the open end of the
spool. Press the spool inwards and the
sleeve, ring, bearing races and thrust
bearing will be pushed out of the housing
together.
(10) Take ring, bearing races and thrust
bearing from sleeve and spool. The outer
(Thin) bearing race can sometimes "stick"
in the housing, therefore check that it has
come out.
(11) Press out the cross pin. Use the special
screw from the end cover.
A small mark has been made with a
pumice stone on both spool and sleeve
close to one of the slots for the neutral
position springs(See drawing).
If the mark is not visible, remember to
leave a mark of your own on sleeve and
spool before the neutral position springs
are disassembled.
5-17
5-73(4)
5-74(1)
5-74(2)
5-74(3)