Hyundai 35DS-7 Operation Manual page 38

(2) Torque converter housing cover, mounting
bolts installed to flywheel housing.
For details, see page 2-9.
(3) Engine accessory
Remove all wiring harnesses, cables and
hoses around the engine, dashboard and
frame.
Wiring harness to alternator and starter.
Wiring harness for oil pressure and
engine water temperature gauges.
Cables for meters, buttons and accelerator
pedal.
Hoses to fuel tank and air cleaner.
Exhaust pipe.
(4) Radiator hose
Open the drain valve of the radiator and
drain the cooling water, then remove the
radiator hose.
(5) Mounting bolt
Attach a crane to the engine hook and
raise, then remove mounting bolts. Raise
the engine slightly, slide towards the
radiator, then lift up.
When sliding the engine, be careful of the
collision engine and radiator.
2) I I NSTALLATION
Installation is the reverse order of removal,
but be careful of the following points.
(1) Tighten the engine mounting bolts and
nuts.
(2) Tighten the engine mounting bracket bolts.
Do not remove the bolts unless necessary.
Loctite is coated over the threads of bolt.
So, once the bolts were removed, coat
them with loctite(#243) when installing.
Before installing the bolts, loctite in the
holes should be removed by a tap.
Engine
5.5-8.3kgf m
(40-60lbf ft)
Mounting bolt
.
7.5kgf m(54.2lbf ft)
Nut
2-12
Engine
D357RE18
Frame
D357RE19
Loctite #243
.
.
Shim
D357RE20