Hyundai 35DS-7 Operation Manual page 69

2) ADJUSTMENT OF PINION SHAFT
Assemble bearing cup.
(1)
Assemble spacer to the pinion shaft and
then install measured shims onto the
spacer.
(2) Insert pinion shaft into the carrier.
Assemble bearing cone and lock nut.
Apply grease on the outer bearing(1).
Apply loctite #271 or #277 on the thread of
pinion and then tighten lock nut.
Tightening torque : 45~51
Measure rolling resistance of pinion shaft.
Adjust shim thickness.
Rolling resistance : 0.20~0.41
Coke lock nut into the pinion shaft slot.
kgf m
(325~369 ).
lbf ft
kgf m
(1.4~2.9 ).
lbf ft
3-27
D357DA281
D357DA29
1
D357DA301