Configuring Option Module Analog Outputs Using Ion Setup; Digital Inputs; Digital Input Applications - Siemens 9810 Series User Manual

Inputs/Outputs

Configuring option module analog outputs using ION Setup

You can configure option module analog outputs using ION Setup.
Analog outputs are available on the optional I/O modules.
Calculate your zero scale and full scale values based on the measured value and the analog
output range of your meter.
Make sure that the analog output port that you want to use is properly connected to an analog
receiver.
1. Start ION Setup.
2. Open the Setup Assistant for your meter.
3. Click Expansion Modules > Option I/O Modules and select the module tab that
corresponds to the option module with the analog output you want to configure.
4. Select the analog output channel and click Edit. Enter the meter password if prompted. The
setup screen for that analog output is displayed.
5. Configure the analog output by selecting the parameter and clicking Edit.

Digital inputs

Digital input applications

Digital inputs are typically used for monitoring the status of switches or contacts, such as status
contacts on circuit breakers.
They can also be used for pulse counting or input metering applications, such as WAGES (water,
air, gas, electricity, steam) monitoring, or conditional energy applications, or IRIG-B time
synchronization.
Pulse mode
If you set Input Mode to PULSE, a pulse is generated at the Trigger output when the State output
changes from OFF-to-ON. No pulse is generated when State changes from ON-to-OFF.
128
Parameter Value/Range
9
Zero scale 0 to ±10
9
Full scale 0 to ±10
Port -
Voltage,
Mode
current
Description
The minimum source value that matches the minimum
analog output signal.
The maximum source value that matches the maximum
analog output signal.
The physical analog output port connection.
Determines whether the analog output is monitoring
voltage or current.
9410 series - User manual
7EN05-0336-09