Siemens 9810 Series User Manual page 68

Communications
Protocol
IPv6
All meters ship from the factory with the IPv6 global address and IPv6 gateway undefined (set to
"::"). To communicate with the meter using IPv6 outside the local network, you must configure
these settings manually or use DHCP to assign the addresses to the meter. Within the local
network, you can use the meter's IPv6 Link Local address.
IP addresses and network port numbers
To specify a port for an outgoing IP address, append a colon then the port number to the end of
the IP address. For IPv6 addresses, enclosed the address in square brackets then add the port
number. For example, to specify the default port for SFTP (port 22):
• IPv4: 169.254.0.10:22
• IPv6: [FE80::260:78FF:FE04:5943]:22
Configurable Ethernet settings
NOTE: Some additional Ethernet settings are available in the Advanced Ethernet menu in ION
Setup and on the meter webpages.
"W" indicates the setting can be configured (written) while "R" indicates it is read-only.
Ethernet configuration settings
Setting
IPv4 address
IPv4 Subnet mask
IPv4 Default gateway
IPv4 Assignment Mode
(DHCP/Stored)
IPv6 Assignment Mode
(DHCP/Stored)
Ethernet Device name
Domain name
IPv6 enabled
IPv6 Link Local Address
IPv6 global address
IPv6 gateway
68
Format
:: to FFFF:FFFF:FFFF:FFFF:FFFF:FFFF:FFFF:FFFF
The double colon indicates that gaps are filled with zeroes to make
the IPv6 address the correct length (32 hexadecimal numbers)
Display ION Setup
W W
W W
W W
W W
W W
R W
R W
W W
R R
R W
R W
9410 series - User manual
Webpages
W
W
W
W
W
W
W
W
R
W
W
7EN05-0336-09