Siemens 9810 Series User Manual page 79

9410 series - User manual
NOTE: For EtherGate functionality, the EtherGate protocol must be enabled and the
applicable serial port set to EtherGate. For Secure EtherGate functionality, select Secure
EtherGate instead of EtherGate.
5. Select a port number from the Port Number drop-down list box or by clicking in the Port
Number field and entering a port number.
6. Click OK.
If multiple ports are set to the same number, ION Setup responds with a message indicating
that the port is already in use by another protocol.
Managing network protocol control using the meter webpages
Use the meter webpages to enable, disable or change the port number of the network protocols
supported on your meter.
The Setup tab contains configurable elements for enabling, disabling, and changing the port
numbers for your network protocols.
When configuring communications parameters, ensure you maintain at least one communication
path that allows full access to your device; otherwise, you may permanently lose the ability to
change your device's configuration and access to additional data.
LOSS OF ACCESS
Failure to follow these instructions can result in loss of access to the device.
Ensure you maintain sufficient access to communicate with and configure your device.
To manage network protocol control using the meter webpages:
1. Open a web browser and enter your meter's IP address in the address bar.
The webpage login is displayed.
2. Enter your login credentials.
3. Navigate to Setup > Ethernet.
4. Click Advanced Settings at the bottom of the screen.
5. Select YES or NO to enable or disable each configurable protocol.
6. Enter the port number for each configurable protocol.
7. Click Apply to send these settings to your meter.
Managing network protocols using the display
The Ethernet Port Enable Setup allows you to enable or disable your network protocols through
the display.
7EN05-0336-09
NOTICE
Communications
79