•
Port bus speed
•
Synchronous transfer
•
Wide transfer
•
Initiator ID
•
Bus reset on startup
•
Bus termination
•
SCSI port reset
Configuring iSCSI
Consult your service representative before making changes to the
CAUTION
default settings.
The iSCSI Configuration page allows you to configure iSCSI parameters. You can configure the following
options:
•
iSCSI alias
•
iSCSI port number
•
iSNSLoginControl
•
iSNSServer
Configuring the SNC
You can change a number of parameters which affect the SNC on the SNC Configuration page. You can
configure the following options:
•
User name
•
New password
•
Confirm password
•
Minimum operating temperature (internal)
•
Maximum operating temperature (internal)
•
Operating temperature warning
•
Identify the SNC
•
Restore defaults
Mapping
The Mapping page displays the default mapping. It allows you to change the mapping by dragging icons
representing the SCSI devices to the appropriate LUN.
If you change the SCSI IDs of tapes or the library attached to the SNC after setting up the SNC the first time,
you must map the devices again. Refer to
38
Connecting to the Ethernet Data Ports
on page 27.
Using the SNC Manager Interface