Configuring the Serial Port
You can configure the serial port using the Serial Port Configuration page.
•
Baud rate
•
Echo
Configuring the Time and Date
You can configure the real-time clock or access a remote time server using the Time & Date Configuration
page.
The SNC must remain powered on for more than 24 hours to ensure
CAUTION
the date and time are set.
Configurable options are the following:
•
Enables/disables the network time protocol
•
Time server
•
Time zone
•
Manually set time
•
Manually set date
Configuring the Ethernet Port
Use the SNC Manager to manually set IP addresses for the data ports,
CAUTION
gateway and subnet mask. Consult your service representative
before making other changes to the default settings.
The Ethernet Port Configuration page configures each port independently. If you change the IP address
of the Ethernet port you are using to access SNC Manager (the mp0), the change does not take effect until
after you reboot the SNC.
•
Enable/disable DHCP
•
IP address
•
IP gateway
•
IP subnet mask
•
Ethernet speed
•
MTU (Maximum Transmission Unit)
Configuring the SCSI Ports
Consult your service representative before making changes to the
CAUTION
default settings.
Each SCSI port is configured separately. The display includes a list of attached devices for each bus. You
can configure the following options:
SNC 450x User's Guide
37