Log Level Choices
INFO
WARN
Where:
INFO =
WARN =
CRIT =
FAIL =
ALL =
Status
Meaning
enabled
The subsystem and log level chosen are masked when in DisplayEventLog
mode
disabled
The subsystem and log level chosen are shown when in DisplayEventLog
mode
Ready.
set displayeventlogfilter scsi warn enabled
Ready.
set DisplayTraceLogFilter [SCSI | all] [port number] [status]
Contact ATAC before using this command.
CAUTION
The set DisplayTraceLogFilter command controls the display of data for specific SNC ports when the
command DisplayTraceLog is enabled. If enabled for a particular SNC port, that port is masked when the
command DisplayTraceLog is issued. The default setting is "disabled" for all ports. Refer to
DisplayTraceLogFilter [SCSI | all] [port number]
Port Number
Meaning
0 or 1
SCSI connection labeled SCSI port 0 or SCSI port 1
all
All SCSI port connections
Status
Meaning
enabled
The chosen port is masked when in DisplayEventLog mode
disabled
The chosen port is shown when in DisplayEventLog mode
Ready.
set displaytracelogfilter scsi 0 enabled
Ready.
SNC 450x User's Guide
CRIT
FAIL
ALL
Information
Warnings
Critical events
Failures
All of the above
on page 65. This command takes effect immediately.
get
85