Table of Contents
Advertisement
Ready.
get SCSIPortResetOnStartup [port number]
Contact ATAC before using this command.
CAUTION
The get SCSIPortResetOnStartup command displays the current status of the SCSI port reset on startup
parameter for a specific port. The default setting is "enabled." Refer to
number] [status]
on page 95.
Port Number
Meaning
0 or 1
SCSI connection labeled SCSI port 0 or SCSI port 1
Ready.
get scsiportresetonstartup 0
Port 0 ScsiPortResetOnStartup = enabled
Ready.
get SCSIPortSyncTransfer [port number]
Contact ATAC before using this command.
CAUTION
The get SCSIPortSyncTransfer command shows whether or not synchronous SCSI transfers have been
enabled for a specific port. Refer to
command must be followed by saveConfiguration restart.
Port Number
Meaning
0 or 1
SCSI connection labeled SCSI port 0 or SCSI port 1
Ready.
get scsiportsynctransfer 0
Port 0 ScsiPortSyncTransfer = enabled
Ready.
get SCSIPortTermination [port number]
Contact ATAC before using this command.
CAUTION
The get SCSIPortTermination command displays the SCSI internal termination for a specific port. Refer
to
set SCSIPortTermination [port number] [status]
saveConfiguration restart.
Ready.
get scsiporttermination 0
Port 0 ScsiPortTermination = enabled
Ready.
SNC 450x User's Guide
set SCSIPortSyncTransfer [port number ] [status]
on page 95. This command must be followed by
set SCSIPortResetOnStartup [port
on page 95. This
73
Advertisement
Table of Contents
