Table of Contents
Advertisement
Bridge Serial Number
Bridge Name
Internal Temperature = 25 C [0 - 70]
For help, type HELP.
Active Configuration = ADIC Config File
Feb
4 2004 14:06:50 A61Z Initialization Complete
Scsi interface 0 Register R/W test
Scsi interface 0 Reset test
Scsi interface 0 FIFO test
Scsi interface 0 Master test
Scsi interface 1 Register R/W test
Scsi interface 1 Reset test
Scsi interface 1 FIFO test
Scsi interface 1 Master test
Initializing Port DP0......................
Initializing Port DP1......................
Initializing Port MP0......................
GBE hardware Init done.
Ready.
• In serial port sessions, there is no prompt on the line below the word Ready.
Note
• No username or password is required for serial port access.
• CLI commands are case insensitive. You can type all upper or all lower case
5
To verify that you have connected successfully, type help after the Ready prompt and press Enter.
If a list of all available commands does not appear on the screen, review the steps in this section, check
the cable, or contact service personnel until the problem is solved.
•
If you wish to change the default username and password for world wide web, Telnet and FTP use,
continue with the section
•
If you are configuring the SNC for the first time, continue with the section
Management
Port.
•
If you were sent to this section by another procedure, return to that procedure.
Connecting to the Ethernet Management Port
The management port IP address (Ethernet port 2, also called the mp0) must be set by issuing a command
from the serial port (refer to
• For best performance, all cabling, network interface cards (NICs),
CAUTION
• It is recommended that you configure host access through a switch.
1
Using at least Cat 5e cable, connect the Ethernet ports to your network switch.
SNC 450x User's Guide
= "IPB2500100136"
= "SNC 450x"
Begin typing commands in the blank line where the cursor is resting.
or a mixture. Upper and lower case in this guide and the Help screen are for
clarification only.
Completing the
Connecting to the Serial Port
host bus adapters (HBAs), and network switches must be Gigabit
Ethernet (GbE), and at least Cat 5e certified. Most standard offices
use 2-pair wiring which is not compatible. GbE requires 4-pair
wiring. For best performance, support for 9600 byte jumbo frames
should be available for all switches and host iSCSI equipment.
Passed
Passed
Passed
Passed
Passed
Passed
Passed
Passed
Installation.
on page 18).
Connecting to the Ethernet
21
Advertisement
Table of Contents
