Table of Contents
Advertisement
0
Bridge
1
0
2
0
3
0
4
0
5
1
6
1
7
1
8
1
9
0
Ready.
routeDisplay iSCSI <lun>
The routeDisplay iSCSI command displays a list of iSCSI names to SCSI bus, target, and LUN mappings.
The optional LUN parameter limits the list to the map of that LUN.
Ready.
routeDisplay iscsi
8
;Lun SB ST SL
;===================
0 Bridge
1 0 0 0
2 0 1 0
3 0 2 0
4 1 4 0
8 1 3 0
Ready.
saveConfiguration <status>
Many commands require a saveConfiguration command to be executed. This is indicated by the output
Ready. *. When you issue the saveConfiguration command, the current configuration is permanently
saved in the SNC and the new configuration becomes the active configuration.
Some commands require a firmware restart to make the requested change permanent. The SNC cannot
automatically determine whether or not to restart. After you issue the saveConfiguration restart command,
a prompt asks you to confirm the restart. You can override this request by typing n on the command line. If
you select the restart option, the SNC executes its complete start up cycle.
You can make several changes through commands and saveConfiguration before implementing the
restart, but once you have restarted the SNC, all the command changes created before the restart and save
are implemented.
Refer to
restoreConfiguration [status]
Status
Meaning
Restart
SNC executes its complete start up cycle
NoRestart
SNC saves the configuration without restarting
The following example shows the response to a saveConfiguration without specifying restart or
norestart:
Ready.
saveConfiguration
[Configuration saved
82
0
0
1
0
2
0
3
0
0
0
1
0
2
0
3
0
9
0
on page 80.
Management Port Command Reference
Advertisement
Table of Contents
