Table of Contents
Advertisement
get EventLog Filter [subsystem]
Contact ATAC before using this command.
CAUTION
The get EventLogFilter command displays the data for specific SNC subsystems. Refer to
EventLogFilter [subsystem] [event level] [status]
Subsystem Choices
GEN
ENET
Where:
GEN =
ENET =
ISCSI =
NVRAM =
PERF =
ECC =
ALL =
get IdentifyBridge
The get IdentifyBridge command displays whether or not set IdentifyBridge is enabled. Refer to
IdentifyBridge [status]
on page 88.
Ready.
get IdentifyBridge
IdentifyBridge = disabled
Ready.
get IPAddress [port number]
The get IPAddress command reports the current IP address, whether it is the default setting, or whether it
was assigned manually or by DHCP. Refer to
[port number] [IP address]
Port Number
Meaning
mp0
Ethernet management port labeled Ethernet port 2
dp0 or dp1
Ethernet data port labeled Ethernet port 0 or Ethernet port 1
all
All Ethernet port connections
The following is an example of the verbose output for a get ipaddress all command:
Ready.
get ipaddress all
5
SNC 450x User's Guide
ISCSI
NVRAM
PERF
General
Ethernet
SCSI protocol of TCP/IP
Non-Volatile Random Access Memory
Performance
Error Correcting/Correction Code
All of the above
get IPDHCP [port number]
on page 88.
on page 87.
ECC
ALL
set
on page 68 and
set IPAddress
set
67
Advertisement
Table of Contents
