Ready.
set bridgename Alpha
Ready.*
set Date [date]
The set Date [mm|dd|yyyy] command sets the date for the SNC if NTP has been disabled. Refer to
SNTP [status]
on page 97 and
Date format
Meaning
mm
Two-digit designation of desired month
dd
Two-digit designation of desired day
yyyy
Four-digit designation of desired year
The following example sets the date to 3/25/2004:
Ready.
set date 03/25/2004
Ready.
set DisplayEventLogFilter [subsystem] [level] [status]
Contact ATAC before using this command.
CAUTION
The set DisplayEventLogFilter command controls what information is displayed for specific SNC
subsystems when issuing the DisplayEventLog command. The filter blocks information for one or all of the
SCSI buses and Ethernet ports. The default setting is "disabled" for all subsystems and levels. Refer to
DisplayEventLogFilter [subsystem] [level]
Subsystem Choices
GEN
ENET
NVRAM
Where:
GEN =
ENET =
ISCSI =
NVRAM =
PERF =
ECC =
ALL =
84
get Date
on page 63. This command takes effect immediately.
on page 64. This command takes effect immediately.
PERF
XCOPY
General
Ethernet
SCSI protocol of TCP/IP
Non-Volatile Random Access Memory
Performance
Error Correcting/Correction Code
All of the above
ECC
ALL
Management Port Command Reference
set
get