Quantum SNC 4500 User Manual page 95

Port Number Meaning
mp0 Ethernet management port labeled Ethernet port 2
Ready.
set ipaddress DP0 172.16.5.198
Ready.*
set IPDHCP [port number] [status]
When enabled, set IPDHCP allows the SNC to acquire its IP address from a network DHCP (Dynamic Host
Configuration Protocol) server. The network must have at least one DHCP server. When disabled, the SNC
uses the default IP address unless changed through the CLI. A saveConfiguration restart command must
be used to permanently save this configuration. Refer to
IPDHCP [port number] on page 68. DHCP is disabled by default. This command must be followed by
saveConfiguration restart.
Port Number Meaning
mp0 Ethernet management port labeled Ethernet port 2
dp0 or dp1 Ethernet data port labeled Ethernet port 0 or Ethernet port 1
all All Ethernet port connections
Status Meaning
enabled Port acquires IP address from network DHCP server
disabled Port uses default IP address unless changed through CLI
Ready.
set ipdhcp all enabled.
Ready.*
set IPGateway [port number] [IP address]
The set IPGateway command controls the current gateway for the SNC Ethernet ports where
xxx.xxx.xxx.xxx is the IP gateway address and if IPDHCP has not been enabled. The default setting is
"0.0.0.0." Refer to get IPGateway [port number]
saveConfiguration restart.
Port Number Meaning
mp0 Ethernet management port labeled Ethernet port 2
dp0 or dp1 Ethernet data port labeled Ethernet port 0 or Ethernet port 1
all All Ethernet port connections
Ready.
set ipgateway all 0.0.0.0
Ready.*
SNC 450x User's Guide
Default value
get IPAddress [port number]
on page 68. This command must be followed by
10.0.0.3
on page 67 and get
89