Table of Contents
Advertisement
Figure 1
on page 4 and
CAUTION
2
Work from the computer attached to the SNC serial port. After the SNC Ready prompt is returned,
change the IP address of the management port by issuing the set IPAddress mp0 command. The
default IP address for the management port is "10.0.0.3." The example below uses a hypothetical IP
address from the user's internal network.
Ready.
set IPAddress mp0 172.17.76.3
Press Enter.
Ready.*
CAUTION
3
After the SNC Ready prompt is returned, issue the set IPSubnetMask mp0 command. The default
subnet mask is "255.255.0.0."
Ready.
set IPSubnetMask mp0 255.255.255.0
Press Enter.
Ready.*
CAUTION
4
After the SNC Ready prompt is returned, issue the set IPGateway mp0 command. There is no default
gateway.
Ready.
set IPGateway mp0 172.17.76.0
Press Enter.
Ready.*
22
Figure 2
on page 4 show the connectors on the SNC.
• Obtain appropriate IP addresses, gateways and subnet masks from
your network administrator.
• The recommended configuration is one where DHCP has been
disabled.
• You must substitute a valid IP address for the IP address used in the
example.
• Some completed configuration commands do not take effect until
you have issued the saveConfiguration command. When this is the
case, the Ready prompt will be followed by an asterisk. You can
issue the saveConfiguration command after each such
configuration command or wait until the end of the configuration
session before saving.
You must substitute a valid subnet mask for the subnet mask used in
the example.
You must substitute a valid gateway for the gateway used in the
example.
Getting Started
Advertisement
Table of Contents
