Quantum SNC 4500 User Manual page 74

; Port
;=================================
DP0
DP1
MP0
Ready.
get IPDHCP [port number]
The get IPDHCP shows if DHCP has been enabled or disabled for any or all SNC Ethernet ports. Refer to
set IPDHCP [port number] [status]
Port Number Meaning
mp0 Ethernet management port labeled Ethernet port 2
dp0 or dp1 Ethernet data port labeled Ethernet port 0 or Ethernet port 1
all All Ethernet port connections
The following is an example of the verbose output of a get IPDHCP all command:
Ready.
get ipdhcp all
5
; Port
;==========================
DP0
DP1
MP0
Ready.
get IPGateway [port number]
The get IPGateway command reports the current IP gateway, whether it is the default setting, or whether
it was assigned manually or by DHCP. Refer to
Port Number Meaning
mp0 Ethernet management port labeled Ethernet port 2
dp0 or dp1 Ethernet data port labeled Ethernet port 0 or Ethernet port 1
all All Ethernet port connections
The following is an example of the verbose output of a get IPGateway all command.
Ready.
get ipgateway all
5
; Port
;=================================
DP0
DP1
MP0
Ready.
68
Address
172.16.5.50
172.16.5.51
172.16.5.198
on page 89. DHCP is disabled by default.
DHCP
disabled
disabled
disabled
set IPGateway [port number ] [IP address]
Gateway
172.16.1.44
172.16.1.44
172.16.1.44
on page 89.
Management Port Command Reference