1
Connect the cable supplied with your SNC to the SNC RS-232 serial port, and from there to the serial
(COM) port on a personal computer.
For the location of this port on the SNC 4500, see
9.
Figure 8
Serial Connector on the SNC 4500
Figure 9
Serial Connector on the SNC 4501
2
If you are using an SNC 4500 with a Scalar 100 and the library is off, turn on the library. After about 15
seconds, when the library has finished booting, turn on the SNC. If you are using the SNC 4501, just
turn on the library.
3
Start a terminal emulation program on the personal computer, and use it to connect to the SNC.
a. For example, if you are using HyperTerminal on a computer running a Windows operating
system, type SNC450x in the New Connection dialog box. Then click OK.
b. In the Connect To dialog box, for the Connect using field select the COM port number to
which your serial cable is connected. Then click OK.
In the COM Properties dialog box select the following values:
•
Bits per second: 115,200
•
Data Bits: 8
•
Parity: None
•
Stop Bits: 1
•
Flow Control: None
SNC 450x User's Guide
Figure
8. For its location on the SNC 4501, see
Figure
19