Quantum SNC 4500 User Manual page 72

The get DPMTU command shows the MTU (Maximum Transmission Unit) used by SNC data ports. Refer
to iSCSI Performance Tuning
Port Number Meaning
dp0 or dp1 Ethernet connection labeled Ethernet port 0 or Ethernet port 1
all All Ethernet connections
The following is a verbose output for the command get DPMTU all:
Ready.
get dpmtu all
4
; Port
;==========================
DP0
DP1
Ready.
Increasing the MTU can improve performance. To fully understand the
Note
implications and network requirements, contact your service representative
before modifying this value.
get EthernetSpeed [port number]
The get EthernetSpeed command displays the speed of the SNC Ethernet ports. Refer to
Performance Tuning on page 107 and
Port Number Meaning
mp0 Ethernet management port labeled Ethernet port 2
dp0 or dp1 Ethernet data port labeled Ethernet port 0 or Ethernet port 1
all All Ethernet connections
Ready.
get ethernetspeed mp0
EthernetSpeed = auto (100)
Ready.
get EventLog
Contact ATAC before using this command.
CAUTION
The get EventLog command displays whether or not EventLog has been enabled. Refer to
[status] on page 87.
Ready.
get eventlog
EventLog = enabled
Ready.
66
on page 107 and set DPMTU [port number] [MTU choices]
MTU
9014
9014
set EthernetSpeed [port number] [speed]
on page 86.
iSCSI
on page 86.
set EventLog
Management Port Command Reference