Table of Contents
Advertisement
In the previous chapter you used the serial port to log on and configure the Ethernet ports. In this chapter
you get instructions for using SNC Manager to set the time and date and to map devices.
• Any changes must be saved by clicking the Submit button and restarting the SNC.
Note
• Clicking the Submit button is the equivalent of entering saveConfiguration norestart
at the command line.
• Multiple changes on multiple SNC Manager pages may be made and saved by clicking
the Submit button before restarting the SNC to permanently save the changes.
Opening an SNC Manager Session
SNC Manager is the recommended management tool for the SNC 4500 and SNC 4501. It is a web-based
graphical user interface (GUI) that allows you to manage the SNC by clicking choices and commands in
traditional GUI fashion or by entering CLI commands directly, as you would in a terminal emulation session.
The minimum requirement for browsers is Internet Explorer 5.5 or Netscape Navigator 6.2.
1
Obtain the IP address of the SNC mp0.
This address was set in
on page 21.
2
Point your browser at the IP address of the SNC.
3
The SNC Manager home page is displayed. Click Enter.
4
Enter the username and password values.
The default value for the username is admin. The default password is
Note
Password. These values are case sensitive.
The SNC Status page appears.
SNC 450x User's Guide
Step 2
on page 22 in the section
Configuring the SNC
Connecting to the Ethernet Management Port
25
Advertisement
Table of Contents
