Table of Contents
Advertisement
Because the Ready prompt is followed by an asterisk, you must issue the
command to complete the change.
set SCSIInitID [port number] [ID choices]
Contact ATAC before using this command.
CAUTION
The set SCSIInitID command specifies the SCSI initiator ID to be used on the specified SCSI port. All maps
coinciding with the user-specified SCSIInitID must be set to offline and becomes invalid upon issuing this
command. Choices are 0 to 15. The default setting is "7." Refer to
on page 72. This command must be followed by saveConfiguration restart.
Port Number
Meaning
0 or 1
SCSI connection labeled SCSI port 0 or SCSI port 1
SCSI Initiator ID Choices
1
2
3
4
5
The following example specifies the SCSI initiator ID on SCSI port 0 as 15.
Ready.
get SCSIInitID 0 1
ScsiInitID = 7
Ready.*
set SCSIInitID 0 15
Ready.*
set SCSIPortBusSpeed [port number] [speed]
Contact ATAC before using this command.
CAUTION
The set SCSIPortBusSpeed command controls the transfer rate at which the SNC negotiates with its SCSI
devices. Choices are fast, ultra, ultra2 and ultra3. The default setting is "ultra3." Refer to
SCSIPortBusSpeed [port number]
restart.
Port Number
Meaning
0 or 1
SCSI connection labeled SCSI port 0 or SCSI port 1
Speed Choices
fast
ultra
Ready.
set scsiportbusspeed 0 ultra2
Ready.*
94
6
7
8
9
10
on page 72. This command must be followed by saveConfiguration
ultra2
saveConfiguration <status>
get ScsiInitID [port number] [ID choices]
11
12
13
14
15
ultra3
Management Port Command Reference
get
Advertisement
Table of Contents
