Quantum SNC 4500 User Manual page 107

The set TraceLogFilter command filters the data for specific SNC ports in the trace log for specific SNC
ports if the set TraceLog command has been enabled. If the TraceLogFilter command is enabled for a
particular SNC port, that port is masked when the command TraceLog is issued. The default setting is
"disabled" for all ports. Refer to
takes effect immediately.
Port Number Meaning
0 or 1 SCSI connection labeled SCSI port 0 or SCSI port 1
all All SCSI port connections
Status Meaning
enabled The chosen port is masked when in TraceLog mode
disabled The chosen port is shown when in TraceLog mode
Ready.
set tracelogfilter scsi 0 enabled
Ready.
set Username [username]
The set Username command specifies username for all Telnet, FTP, and SNC Manager web server
sessions. The name is case insensitive and must be from 1 to 32 characters with no spaces. The default
setting is "admin." Refer to
saveConfiguration norestart.
Ready.
set username alpha
Ready.*
set VerboseMode [status]
The set VerboseMode command specifies the detail of feedback for the CLI. Disabling this option removes
parameter names from action commands and removes descriptions from information commands. The
default setting is "enabled." Refer to
Status Meaning
enabled Provides labels of parameters after Enter
disabled Removes labels of parameters after Enter (only output data is shown)
Ready.
set verbosemode disabled
Ready.
set WrapEventLog [status]
Contact ATAC before using this command.
CAUTION
SNC 450x User's Guide
get TraceLogFilter [SCSI | all] [port number]
get Username [username]
get VerboseMode
on page 77. This command
on page 77. This command must be followed by
on page 77. This command takes effect immediately.
101