Table of Contents
Advertisement
Installing the SNC
The SNC 4500 is installed on a desktop or in a rack near the Scalar 100. The SNC 4501 is installed directly
into the rear of the Scalar 24.
Installing the SNC 4500 on a Desktop
1
Place the SNC 4500 on a desktop near the Scalar 100.
2
Connect the SNC AC power cord from the SNC to a proper AC source outlet.
The SNC should be left on to keep the battery charged. If the SNC is left
Note
unpowered for long periods of time, you may need to reset the time and date.
For instructions, refer to
3
Proceed to the section
Installing the SNC 4500 in a Rack
1
Using the screws provided, screw the bracket's flat side to one side of the SNC, matching the holes in
the bracket with the holes in the SNC as shown below.
2
Repeat on the other side.
8
Setting the Date and Time
Connecting the SCSI Ports
on page 26.
on page 11.
Getting Started
Advertisement
Table of Contents
