Table of Contents
Advertisement
The get SpeedWriteDefault command shows if SpeedWrite performance has been enabled or disabled for
newly-mapped SCSI devices. For an explanation of the SpeedWrite capability, refer to
[sb st sl | all] [status]
on page 98.
Output
Meaning
enabled
Provides enhanced performance of WRITE commands for newly-mapped
SCSI devices
disabled
Retains the current level of performance of WRITE commands
Ready.
get speedwritedefault
SpeedWriteDefault = disabled
Ready.
get Temperature
The get Temperature command displays the current internal temperature of the SNC in degrees Celsius.
There is no set version of this command.
Ready.
get temperature
Temperature = 32 C
Ready.
get Time
The get time command displays the current time. Refer to
Ready.
get time
Time = 14:47:17
Ready.
get TimeZone
The get TimeZone command displays the current time zone. The "+" and "-" represent a numerical offset
from GMT (Greenwich Mean Time). Refer to
Ready.
get timezone
TimeZone = EST
Ready.
get TraceLog
Contact ATAC before using this command.
CAUTION
The get TraceLog command shows whether or not trace log recording has been enabled. Refer to
TraceLog [status]
on page 100.
Output
Meaning
enabled
SCSI traffic is recorded to the Trace Log
76
set Time [time]
set TimeZone [zone] [+/-:hh:mm]
Management Port Command Reference
set SpeedWrite SCSI
on page 99.
on page 100.
set
Advertisement
Table of Contents
