Table of Contents
Advertisement
Figure 38 Multi-Unit
Screen
Configure Multi-Units (P2000/P3000)
Back
About
Quantum|ATL
Operator
System
Multi-Unit
Off-line
Standby
Load Port
O
Stop
The Configure Multi-Unit command allows you to set the
following:
• Library Unit field—sets whether the library is single, slave, or
master in the multi-unit configuration
• Library Unit # field—sets the number assigned to a particular
library in the multi-unit configuration. Libraries are numbered
left to right beginning with 0 and ending with 4
• # of Libraries field—sets the total number of libraries in the
multi-unit configuration
• LUN Config field—this option will always be set to Single LUN
To configure a Multi-Unit Library option:
In the Multi-Unit screen, press the Configure Multi-Unit
1
button.
The GUI displays the Configure: Multi-Unit screen (see
figure
39).
Quantum|ATL P3000 Series User's Guide
Chapter 5 Multi-Unit Commands
Configure Multi-Units (P2000/P3000)
Forward
Home
Multi
Service
Unit
Configure
Multi-Unit
Calibrate
All PTMs
5
67
Advertisement
Table of Contents
