Closing The Library Doors And Access Panels; Connecting Host Workstations - Quantum P3000 Series User Manual

Closing the
Library Doors and
2
Access Panels
Connecting Host
2
Workstations
The library has two front doors and three back access panels.
Close and lock the front doors.
1
Close one door and then the other.
a
Turn the door latches to secure the doors to the library
b
frame.
Lower the latches over the door locks.
c
Using the key from the accessory kit, lock the latches in
d
place.
Close and lock the back access panels using a 5/32 hex wrench
2
(not provided).
Connect the SCSI cables and jumpers as shown in the applicable
figures.
Quantum|ATL ships sufficient SCSI cables and
Note:
terminators with this library to set up two-drives per
SCSI bus, as well as adequate SCSI jumper cables to
accommodate up to 4 drives per SCSI bus.
Figure 11 shows the recommended cabling configurations for the
16-drive library.
Quantum|ATL P3000 Series User's Guide
Chapter 2 Basic Library Operations
Preparing the Library for Operation
21