Moving Cartridges - Quantum P3000 Series User Manual

Chapter 3 Operator Commands

Moving Cartridges

Moving Cartridges
50
Press the Abort button to stop continuous running of the
2
inventory process, otherwise, the process will continue until all
storage elements have been inventoried.
The inventory process is also stopped if an error is
Note:
detected. In this case, the GUI displays an error
message.
The Move Cartridges command allows you to move any tape
cartridge in the library to the destination you specify. This
destination can be a storage bin, a tape drive, the load port, or the
gripper.
To move a cartridge from a tape drive, issue an Unload
Note:
Drive command as explained in
To move a cartridge:
In the Operator screen, press the Move Cartridges button.
1
The GUI displays the Control: Move Cartridges screen, with
the Source input field active (see
Quantum|ATL P3000 Series User's Guide
"Unloading a Drive."
figure 27).
3