Gui; Mode Select Command; Reporting Of Cleaning Mode; Diagnostic Software - Quantum P3000 Series User Manual

3

GUI

Mode Select
3
Command

Reporting of Cleaning Mode

Diagnostic
3
Software
To change automatic cleaning mode from the touch screen GUI,
select
Configuration/Auto Clean
• - turns automatic cleaning mode on
Enable
• - turns automatic cleaning mode off
Disable
To change the automatic cleaning mode using the Mode Select
command set the Vendor Unique Page (20h) byte 2, bit 1 (AC) to:
• One - enable automatic cleaning
• Zero - disable automatic cleaning
To save the automatic drive cleaning mode setting in NVRAM set
the Mode Select command Save Page (SP) bit to one.
When the automatic drive cleaning mode setting is saved in
NVRAM, neither a SCSI bus reset or a power cycle of the Product
Name will change the mode setting.
The current drive cleaning mode can be reported by:

• Diagnostic Software

• Mode Sense command
To display the current drive cleaning mode from diagnostic
software select:
•
Config/Report Clean Tape
The diagnostic screen will display the:
• Current cleaning mode
• Bar code label of each cleaning cartridge
Quantum|ATL P3000 Series User's Guide
Appendix C Automatic Drive Cleaning
Reporting of Cleaning Mode
:
3
101