Table of Contents
Advertisement
SCSI ID
Assignment
3
Guidelines
Configuring Library Options
Press the Select button until you highlight the setting you want
3
to change.
Using the arrow buttons, scroll through available values for the
4
setting.
Press the Change button to accept the new value.
5
Repeat steps 3 through 5 to make other changes.
6
Press the Back button to return to the Configure: Library
7
screen.
The options you selected are now part of the library configuration.
When selecting SCSI ID numbers, each SCSI device on the same
bus must have a unique number from 0 to 15. SCSI devices include
the library robotics, the host computer, the library tape drives,
internal and external hard disk drives, and so on.
If you set up the library with multiple SCSI buses, you can assign
the same number to two or more devices, provided each device is
on a different SCSI bus.
Power must be cycled for the new SCSI ID number to
Note:
become effective.
The Configure Options command allows you to set the following:
• Power-On State—determines whether the library is on-line or in
standby mode when powered up. The default setting is On-
line.
• AutoClean—allows the library to perform drive cleaning tasks
automatically as needed. The default setting is Disabled.
Quantum|ATL P3000 Series User's Guide
Chapter 3 Operator Commands
Configuring Library Options
3
47
Advertisement
Table of Contents
