Configuring, Installing, and Operating the Tape System
2.2.4 Installing the Tape System
Installing the tape system requires securing the tape system in its bay or chassis and
connecting SCSI bus and power cables.
2.2.4.1 Securing the Tape System in Bay or Chassis
Using four (4) screws, secure the tape system in its bay or chassis.
Figure 2-4 is a dimensional drawing that shows the locations of the mounting holes at
the bottom and sides of the tape system.
Note that screws used to mount the tape system must be #6-32 UNC-2B screws. When
the recommended size screws are used, there is no danger of the screws touching
electronic components or otherwise damaging the tape system.
2-8
Quantum DLT 8000 Tape System