Quantum DLT 8000 Product Manual page 243

MODE SELECT Command (6) / (10) (15h) / (55h) (continued)
Table 5–47 EEPROM Vendor Unique Page Parameters (continued)
Name Value Rep.
ASCII Binary
FORCEREADSILI
CACHETMS ASCII Decimal
ASCII Binary
LDRCYCLRESET
ENAREPDECOMP ASCII Binary
SCSIRESRELNOP ASCII Binary
DISUNBUFMODE ASCII Binary
NODEFERRCVDERR ASCII Binary
CALRETRY ASCII Decimal
Length
Default (Bytes)
0 1
0 1
0 1
0 1
0 1
0 1
0 1
2 1
Quantum DLT 8000 Tape System
SCSI Commands
Usage
To make variable READ command
handled as if the SILI bit is set if set.
0,1 = Do not cache filemarks unless
IMMED bit is set (if set)
2 = Cache if not two in a row unless
IMMED bit is 1.
3 = Always cache filemarks.
To cause the first cartridge to be loaded
if unloading the last cartridge when the
loader product is operated in sequential
mode (if set).
If set and the drive is in READ mode, the
decompression algorithm field in Data
Compression mode will be reset if the
last block requested by the host was
decompressed, otherwise it is cleared.
SCSI Reserve / Release Unit commands
are no operation (if set).
The drive disables unbuffered mode,
i.e., it ignores the MODE SELECT
"buffered mode" selection to turn off
buffered mode (if set).
The drive reports deferred recovered
error as current recovered error (if set).
0 = no retry
1 = one retry
2 = 2 retries
3 = 3 retries
5-99