Quantum DLT 8000 Product Manual page 244

SCSI Commands
MODE SELECT Command (6) / (10) (15h) / (55h) (continued)
Table 5–47 EEPROM Vendor Unique Page Parameters (continued)
Name
SCSIBUSDMATIMER
SCSIRESELRETRIES
SCSIRDYEARLY
REPORTRCVRDERR
NORDYUAONUNLD
HOSTCOMPSETTING
REDUNDANCYMODE
REPBUSYINPROG
5-100
Value Rep. Default
ASCII Decimal 2
ASCII Decimal 10
ASCII Binary 0
ASCII Binary 0
ASCII Binary 0
ASCII Decimal 0
ASCII Decimal 0
ASCII Binary 0
Quantum DLT 8000 Tape System
Length
(Bytes) Usage
1 The number of seconds until the drive
times out waiting for ACK once DMA
transfer started. When set to 0, the
timer is set to infinite.
1 The number of reselection retries the
drive makes before giving up. Each
reselection retry occurs every 1 second.
When set to 0, the drive does infinite
reselection retries.
1 The drive reports READY status earlier
(if set).
1 This parameter sets the default value of
PER bit of READ / WRITE Error Recovery
Mode page (01h).
1 When set, Not Ready to Ready Transition
unit attention will be removed from the
unit attention queue upon a successful
unload.
1 This parameter allows the host to
change the compression setting. Note
that there is a tradeoff between best
performance and best compression; if
the compression setting = 1, it provides
the best performance but the worst
level of compression. If the setting = 15,
it provides lowest performance but
maximum compression. Settings for the
HOSTCOMPSETTING parameter are:
0 Use default compression setting
1 Set compression setting for best
performance
2 Set compression setting for best
compromise of performance and
compression
3 Set compression setting for best
compression
NOTE: This information for DLT 8000
format only
1 Sets the value of the allowed maximum
marginal channel (0 - 1 allowed).
1 When set, report busy status if the drive
is in the process of becoming ready.