Messages
4.2.6 IGNORE WIDE RESIDUE Message (23h)
The IGNORE WIDE RESIDUE message is sent by the target to the initiator to indicate
that the number of valid bytes sent during the last REQ/ACK handshake and
REQB/ACKB handshake of a DATA IN phase is less than the negotiated transfer width.
The Ignore field indicates the number of invalid data bytes transferred. This message is
sent immediately following that DATA IN phase and prior to any other messages. Figure
4-3 illustrates the data format of an IGNORE WIDE RESIDUE message. Table 4-6
describes the Ignore field bit definitions.
Bit
7
Byte
0
1
Figure 4–3 IGNORE WIDE RESIDUE Message — Data Format
Table 4–6 IGNORE WIDE RESIDUE Message — Field Definition
Ignore
02h - FFh
4-8
6
5
00h
01h
Quantum DLT 8000 Tape System
4
3
Message Code (23h)
Ignore (01h)
2
1
Invalid Data Bits
16-bit Transfers
Reserved
DB(15-8)
Reserved
0