Table C–2 Results Of Firmware Update - Quantum DLT 8000 Product Manual

Table C—2 Results of Firmware Update (continued)
If...
1. The tape is NOT a valid firmware update tape
2. The tape does not contain a valid firmware
image
The tape contains a valid image but there is a
failure when attempting to reprogram FLASH
EEPROM
Then...
No firmware update is attempted. The WRITE
PROTECTED and TAPE IN USE indicators do not
blink. The drive resets and the tape remains
loaded to signal that the firmware update was
unsuccessful.
The controller PCBA is probably unusable and
should be replaced. The tape drive performs a
reset and reruns POST. POST will fail if FLASH
EEPROM does not contain a valid firmware
image.
Quantum DLT 8000 Tape System
Appendix C: Updating the Firmware
C-5