Connecting The Scsi Bus Cables; Figure 2-9 Location Of Scsi Bus Connectors On Rear Panel (Tabletop Version) - Quantum DLT 8000 Product Manual

Configuring, Installing, and Operating the Tape System

2.3.2 Connecting the SCSI Bus Cables

Figure 2-9 shows the locations of the two SCSI bus connectors on the rear panel of
the tabletop tape system. The SCSI bus cable leading from the host adapter can be
connected to either of the connectors. If the tape unit is the last device on the bus,
then a terminator should be installed on the open connector. If the bus continues
from the tape system to another SCSI device, then install a SCSI bus cable between
the open connector and the next device on the bus.
SCSI Connectors (2)
68-Pin LVD/SE Terminator: Quantum 12-60308-01
68-Pin HVD Differential Terminator: Quantum 12-41769-01
Figure 2–9 Location of SCSI Bus Connectors on Rear Panel
2-18
Terminators
(Tabletop Version)
Quantum DLT 8000 Tape System