Quantum DLT 8000 Product Manual page 245

Table 5–47 EEPROM Vendor Unique Page Parameters (continued)
Name
THIRDPARTYDEN
ENAGRANULARITY
ENASCSIFILTER
ENAREQACKACTNEG
SETEOMATBOM
SETEOMATEW
REPUAONSEQUNLD
DISDEFERCLNRPT
ENASCSIUNLONPMR
MAXBURSTSIZE
SPEEDSETTING
TAMRIEDEFAULT
Value Rep. Default
ASCII Decimal 0
ASCII Binary 1
ASCII Binary 1
ASCII Binary 1
ASCII Binary 0
ASCII Binary
0
ASCII Binary 0
ASCII Binary 0
ASCII Binary 0
ASCII Binary 0080h
ASCII Decimal 3
ASCII Binary 3
Quantum DLT 8000 Tape System
Length
(Bytes) Usage
1 Value of default third party density.
Requires ENATHIRDPARTYDENS = 1
1 Enables granularity field in READ BLOCK
LIMITS command.
1 Enables SCSI filter on SCSI chip.
1 Enables active negation on REQ and ACK
signals
1 Sets EOM field in byte 2 of Request
Sense data when encountering BOM
1 Sets EOM field in byte 2 of Request
Sense data when encountering Early
Warning end of media for all operations
1 When set, the drive reports a Not Ready
to Ready Transition Unit Attention when
an autoloader loads the next cartridge
1 When set, a cleaning report is sent over
the library port as soon as the cleaning
light illuminates. If this parameter = 0,
then the report is sent only at unload.
1 When set, enables a SCSI Unload when
a previous Prevent Media Removal
command is in effect
2 The value in this field specifies the
maximum amount of data to be
transferred without disconnecting. A
value of 0 sets no limit. This value is
given in 512 byte increments. For
example, a value of 8 indicates 4K bytes.
Values that are not multiples of 8 are
rounded up to the nearest multiple of 8.
Minimum value of this field is 0000h,
maximum is FFFFh.
1 0 = Drive will match host bus speed
1 = Bus Speed Below 5.0 MB/sec
2 = Bus Speed 5.0 – 6.0 MB/sec
3 = Bus Speed of 6.0 MB/sec or more
NOTE: This information applies only
to DLT 8000 format.
1 The value in this field is the value to be
set in the Tape Alert Mode Page (1Ch)
MRIE parameter. Minimum value is 0;
maximum value is 6.
SCSI Commands
5-101