Quantum DLT 8000 Product Manual page 263

MODE SENSE (6) / (10) Command (1Ah / 5Ah) (continued)
Table 5–54 DISCONNECT / RECONNECT Error Recovery Page — Field Descriptions
Field Name
PS
Additional Page Length
Buffer Full Ratio
Buffer Empty Ratio
Bus Inactivity Limit
Disconnect Time Limit
Connect Time Limit
Maximum Burst Size
DTDC
Description
Parameters Savable. When 0, the supported parameters cannot be
saved (savable pages are not supported). When set to 1, it indicates
that the page can be saved in nonvolatile memory by the drive.
This field indicates the number of bytes in the page. Note that this
value does not include bytes 0 and 1. The length is returned on
MODE SENSE and must subsequently be set to the same value when
performing MODE SELECT.
Not supported.
Not supported.
Not supported.
Not supported.
Not supported.
The value in this field specifies the maximum amount of data to be
transferred without disconnecting. A value of 0 sets no limit. This
value is given in 512 byte increments. For example, a value of 8
indicates 4K bytes. Values that are not multiples of 8 are rounded up
to the nearest multiple of 8.
Data Transfer Disconnect Control. The value in this field specifies the
restriction when a disconnect is permitted.
Quantum DLT 8000 Tape System
SCSI Commands
5-119