Ricoh R-C4 Service Manual page 263

21 July 2006
6105* Staple Position Adjustment
Adjusts the staple position in the main scan direction when using the two-tray
finisher.
[–3.5~+3.5 / 0.0 / 0.5 mm step]
Press
paper.
6117 Finisher Input Check
Displays the signals received from finisher sensors and switches. (
6118 Finisher Output Check
Switches on each electrical component of the finisher for testing. (
Press
6802 ADF Mounted
Displays the model number of the ADF (ALPS-C-0x03) installed on the machine.
6901 ADF APS Data Display
Displays the status of the original size sensors in the ADF. ( 5.1.9)
6910* ADF Shading Interval Time
Adjusts the interval for shading processing in DF mode.
Light and heat may affect the scanner response. If copy quality indicates that
white level is drifting during a DF copy job, reduce this setting.
[0 ~ 120 / 20s / 1s/step]
6920 DF Check
6920 1 DF GATE IN
6920 2 DF TXD Break
6920 3 Serial Communication
6920 4 Original Set
6920 5 Serial Check
6925 Bridge/Duplex/By-Pass/Loop Back DFU
6925 1 Practice
6925 2 Result
±
to toggle . A larger value shifts the staple toward the edge of the
to switch on or to switch off.
DFU
0 = Gate, 1 = Asart
DFU
0 = Off, 1 = On
DFU
0 = NG, 1 = OK
DFU
0 = Off, 1 = On
DFU
DFU
DFU
5-75
SERVICE PROGRAM MODE
5.1.5)
5.1.6)