Page 1
RICOH Ri 100 Notes for Wireless LAN Users This manual explains how to connect the machine to the network via a wireless LAN interface in the infrastructure mode. In the infrastructure mode, communication is established via a wireless LAN access point.
Page 2
Plug the wireless LAN cable into the Ethernet port before configuring the wireless LAN settings. DSA343 Selecting the Configuration Method The configuration method depends on the access point being used. "Easy Setup" is a function for automatically configuring the wireless LAN settings. The actual name of the function may vary depending on the access point being used.
Page 3
Easy Setup Using the Push Button Turn the machine on. DSB151 Press the [ /Menu] key. Press the [ ] or [ /Menu] key to display the [Host Interface] menu, and then press the [#Enter] key. <Menu> Host Interface Press the [ ] or [ /Menu] key to display [Wireless LAN], and then press the [#Enter] key.
Page 4
Press the [ ] or [ /Menu] key to select [PBC Method], and then press the [#Enter] key. <Easy Setup> PBC Method If the access point cannot be detected within 120 seconds, the search session expires. If the connection attempt has failed, press the [#Enter] key again. If the problem persists, check whether the access point is working properly.
Easy Setup Using a PIN Code Turn the machine on. DSB151 Press the [ /Menu] key. Press the [ ] or [ /Menu] key to display the [Host Interface] menu, and then press the [#Enter] key. <Menu> Host Interface Press the [ ] or [ /Menu] key to display [Wireless LAN], and then press the [#Enter] key.
Page 6
Enter the machine's PIN on the access point web page. CHV609 For details, see the manual supplied with the wireless LAN access point. Execute WPS (PIN system) from the access point's web page. 10. Press the [Escape] key. 11. Press the [ ] or [ /Menu] key to select [PIN Method], and then press the [#Enter] key.
Manual Setting If you cannot confirm the settings of the access point being used or the access point does not support WPS, configure the wireless LAN settings manually. You can configure the settings using Web Image Monitor or the control panel. This manual mainly explains configuration using Web Image Monitor.
Page 8
In the menu area, click [Settings]. Click [Wireless LAN Settings]. Specify the wireless LAN settings. If the security method is WEP DSB202 1. Enter the network name of the access point. 2. Select [WEP]. 3. Enter the password for the access point, and then select the [Apply] check box.
Page 9
If the security method is WPA DSB203 1. Enter the network name of the access point. 2. Select [WPA].
Page 10
• If the WPA authentication method is WPA-PSK or WPA2-PSK DSB205 1. Select [WPA-PSK] or [WPA2-PSK]. 2. Enter the PSK (Pre-Shared Key), and then select the [Apply] check box. Configure other settings if needed.
Page 11
• If the WPA authentication method is WPA or WPA2 DSB204 1. Select [WPA] or [WPA2]. 2. Enter the user name for Extensible Authentication Protocol (EAP). 3. Select the EAP authentication type. 4. Enter the password for Protected Extensible Authentication Protocol (PEAP), and then select the [Apply] check box.
Need help?
Do you have a question about the Ri 100 and is the answer not in the manual?
Questions and answers